
Electrical fault finding in South Croydon for trips, dead sockets, flickering lights and anything else that isn't working as it should. We test methodically to find the real cause, and there's no call-out charge.

Typical problems include RCDs or breakers that keep tripping, sockets or lights that have stopped working, flickering, buzzing switches and appliances that cut the power when switched on. Each has several possible causes, from a worn accessory to damp in an outside light or damaged cable inside a wall.
We start by narrowing the problem down to one circuit, then test insulation resistance, continuity and polarity along it. Unplugging appliances one at a time helps rule them out. Working step by step finds the cause, rather than resetting the switch and hoping it holds.
A breaker that trips again after resetting is doing its job, which means the cause is still there. Ignoring it, or swapping it for a bigger breaker, can leave wiring overheating. Finding and fixing the underlying problem is the only safe way to stop the trips.
Before we visit, we ask when the problem started, what was switched on at the time and whether anything has changed, such as new appliances or building work. On site, we check the consumer unit, isolate the affected circuit and work through it with test equipment until the fault shows up.
Once we've found the cause, we explain it in plain terms and tell you what the repair involves. Small repairs can often be done straight away, and bigger ones get a free quote first. Every repaired circuit is tested before we switch it back on.
Call or send a message about the job. For urgent faults we aim to respond the same day, with no call-out charge.
An electrician comes out, checks the job and talks you through the options, then you get a free, no-obligation quote.
When the work is finished, we test everything we've worked on and hand over the right certificate for the job.
Usually because an RCD or breaker has detected a problem, such as a faulty appliance, moisture in an outdoor fitting or damaged cable. Unplug everything and reset it. If it trips again with nothing plugged in, the fault is in the wiring and needs an electrician to trace it.
It depends on how long the fault takes to trace, which isn't always clear at the start. Some are found in minutes, while faults that come and go can take longer. There's no call-out charge, and we'll explain the likely cost when we arrive and before doing any repair work.
Yes, though intermittent faults take more patience. Keeping a note of when the trips happen, such as during heavy rain or when certain appliances are on, helps a lot. We test the circuits for weak points that may not show up every day and fix what we find.
Sometimes it's just a failing bulb or a dimmer that doesn't suit LED lamps. But flickering across several lights, or with buzzing or a burning smell, can mean a loose connection, which can overheat. If changing the bulb doesn't fix it, it's worth having it checked.
We trace electrical faults in the areas below. Select yours to find out more.
Describe the fault and when it tends to happen, and we'll arrange a visit to track it down.