
Fire alarm installation in South Croydon for offices, shops, workplaces and residential blocks. We install systems with detectors, call points and sounders designed around your fire risk assessment, with a free quote first.

Small premises often use a conventional system, where the panel shows which zone has a problem. Larger buildings usually benefit from an addressable system, which pinpoints the exact detector or call point. The choice depends on the size and layout of the building and how it's used.
Commercial fire alarms are designed to BS 5839-1. Systems are graded by what they protect, from life safety along escape routes to coverage of the whole building to protect property. Your fire risk assessment sets the category your premises needs.
A fire alarm should be tested every week by operating a different call point each time, and serviced by a competent person at least every six months. Every test, service and false alarm is recorded in the fire alarm log book.
We start with your fire risk assessment and a walk round the building to see the layout, escape routes and how each area is used. We then design the system, choose the panel, detectors, call points and sounders, and give you a free quote with the layout.
We install and wire the system, programme the panel and test every device. Before handover, we show the responsible person how to carry out the weekly test, silence and reset the panel and use the log book. You receive the certificates for the installation.
Call or send a message about the job. For urgent faults we aim to respond the same day, with no call-out charge.
An electrician comes out, checks the job and talks you through the options, then you get a free, no-obligation quote.
When the work is finished, we test everything we've worked on and hand over the right certificate for the job.
Most businesses need a way to raise the alarm in a fire, and the fire risk assessment decides what's suitable. A small single-storey shop may need very little, while offices, restaurants and larger premises usually need a full system. We can install what your assessment calls for.
Yes. We can replace an old panel, add detectors to new areas or upgrade a conventional system to an addressable one. Sometimes the existing wiring can be reused, which keeps the cost down. We'll test what's there and explain the options.
At least every six months, by a competent person, as recommended in BS 5839-1. Busy or high-risk premises may need more frequent visits. The weekly call point test can be done by your staff, and everything should be recorded in the log book.
Common causes include dust, steam or cooking fumes reaching detectors, detectors of the wrong type for the room, and accidental damage to call points. Using heat detectors in kitchens and positioning devices carefully cuts false alarms, which matters because frequent ones make people ignore real alarms.
We install fire alarms for premises in the areas below. Choose yours to find out more.
Send us your fire risk assessment or floor plan, and we'll design a fire alarm system and quote for it.